Recent content by DIY

OK. Interesting.   So I tested the device with water and looked at the Event Viewer. Lots of Device Communications Messages in there. More importantly, I saw the 'Wet' sensor go from 'Off' to 'On' and back to 'Off' again as I took the sensor back out of the water. I then did the same thing while...

Awesome.   I need to run out the door in a moment but wanted to quickly reply to as much of what you raise as possible since you've been so responsive to my Qs...   Sensor status appears to be correct (Dry:On, Wet:Off). There's an obvious check I could do here, just haven't done it yet. Program...

Greetings again Cocooners...   I have an Insteon Water Leak sensor 2852-222) that I'm trying to get to send a notification with my ISY994i (v.4.0.5). The device appears to be Linked to the ISY and I see 2 devices: 'Water Sensor-Wet' and 'Water Sensor-Dry'  My ISY e-mail configuration appears to...

Oberkc,   With your help and some interactive troubleshooting I think I now have this working the way I want it to. In Summary:   'ON' on either KPL turns both lights on. 'ON' on either KPL-A turns Light-1 on. 'ON' on either KPL-B turns Light-2 on. 'Off' on either KPL turns everything off...

Thanks for the suggestions guys. I will look at adding additional responders and that might help a bit. Sorry if my original post was at all unclear. Let me try to re-clarify. This seems fairly simply in my own mind but I'm probably not conveying it properly.   Basically what I think I want is...

Oberkc,   These are great points. I'm starting to notice how Programs can take an extra half-second or so to respond, and I do notice there is a slight delay between when my first light comes on and my second. Given the approach we both seem to like (of using a program for this) then maybe a...

All,   I have another relatively easy question that I hope someone can provide a fairly easy answer to. I have a very simple setup in my kitchen in which I've replaced 2 standard switches that drive 2 separate under-cupboard lights and I've replaced them both with Insteon KeypadLinc 6-button...

az1324,   Thanks again for the pointer. I followed one of the examples on that wiki (2nd one as I recall) and modified it just a bit to suit my purposes. I'm still in the testing phase but so far it seems to be working exactly like I wanted. The PIRs themselves are on a 30 second timeout and...

I did not. :-)   Lots of good examples there. I'll dig through them and try a few and report back on the results. Thanks!

Greetings,   I have a scenario that I'm trying to build with Insteon devices and my ISY99. I've almost got it working the way I'd like but not quite 100%. Any assistance would be appreciated.   The area in question is my stairwell into my basment laundry room. You access this area from either...

Thanks for the quick responses guys. That answers my question. :-)

All,   I have a very basic question hopefully someone can easily answer. I'm installing an Elk M1 alarm system in my home and was wondering if there is a definition for the term 'Area' in the GUI. When I initially started planning my system I thought an area could be the perimeter (like the...