Recent content by dman782

I have a base setup for testing.  in my OP, read control as keypad. So all I have is the board, power, and 1 Keypad.  In the few seconds that it stays up, the keypad says it has ID 2.  I'm not sure if that matters.  I'm a software guy so I'm hoping there's a factory reset jumper, but thus far i...

Thank you both for the quick response.   Maybe; but, your point is taken.  However, I'm still not convinced it's the battery, so I guess I'll go spend 20 bucks. And I may find out that ignorance is expensive.   Ral, I did take off the back for inspection.  No burns or odd smells. I just don't...

I'm a newby to M1 and Home Automation.  I recently purchased a M1 Gold.  I had everything installed and began programing.  I noticed the system was constantly alerting about a low battery.  Not really caring about this situation, because I had the system down for some weeks and never really gave...