Recent content by dooger54

I have a 220V submersible well pump I want to be able to turn off/on remotely using my HA Omni and UPB system. All of the UPB I/O controls I see can only handle 110. HOw do I do this??

How do you mask off part of the field? I'm not familiar with how this is done.

Unfortunately, yes, this one pretty much has to be wireless.

I am looking for a wireless motion detector to use with my HAI Omni Pro II panel. I want one that will detect motion only when someone walks through a doorway. I do not want one that detects a wide area. Any suggestions?

I'm just getting started building my HA system by adding some UPB switches. I have the following scenario I want to program: In our second floor master bedroom, I want a light to come on automatically when someone walks into the room after dark. I am planning on adding a motion detector wired...

DavidL- If the ethernet plugin is being added now, that is great. FYI, I went onto the HAI forum at the MainLobby website and found quite a thread about this plugin. Seems Cinemar has been promising since the first of 2007 to have the ethernet plugin done, to no avail. Hope what you say is...

Steve- I had looked at CQC about a year ago, and never did go ahead. Looking at it again raises a few questions- 1) On their site I didn't see any support for "generic" UPB. That would be a deal breaker. 2) CQC seems like it might be more difficult to initially set up than MainLobby. I...

David- I am planning on downloading a trial version of ML and giving it a go. One concern I do have is the the HAI plugin uses the serial connection on my HAI board, instead of wireless ethernet TCP/IP. I saw where the ethernet version was being discussed, but I don't see if it was ever...

Hi Everyone- Just found this forum after searching for a long time over the weekend. I've been looking for help on setting up HA in our home using UPB and couldn't find much help until I stumbled onto this site via Google. Thank goodness! My current setup is as follows: 1) HAI Omni Pro II...