Recent content by equitax

Hi There,   Looking for some help with some communication issues between HAI Omnistat 2 and Elk M1 controller:   Seems that the Controller can send commands to the tstat successfully, but the ELK cannot be programmed to "do" anything based on information from the stat (such as a rule WHEN...

Hi There,   Looking for some help with some communication issues between HAI Omnistat 2 and Elk M1 controller:   Seems that the Controller can send commands to the tstat successfully, but the ELK cannot be programmed to "do" anything based on information from the stat (such as a rule WHEN...

Also to clarify the version of firmware that was on my zero was pre 1.3.28, which is why I needed to up to 1.3.28 first. Maybe if I stopped there my issue would have been resolved also. But i did not test at that stage.

Hi all. The upgrade of firmware solved the problem with no changes on the router. my firmware and boot ware were ancient. I needed to update boot ware in 2 steps and then the firmware once. Good to have this online. Thanks all for your help!

Have tried everything. Including dmz. I have 2101 26 and 2501 forwarded to the static ip. It only fails if secure. Tried setting secure port to 2101 that doesn't work either. I connect using elk rp or ekeypad. Hope firmware is the problem. Getting mighty frustrated.

Yikes - Boot ver is 1.14, Firware is 1.2.14 - I suppose the upgrade is in order..  Can I go straight to 2.0.34 or does it need to be done in steps.   I don't want to Brick it...

Port is open and visible. Weird thing is that 2101 as non secure works from anywhere. Lab or wan. Il is static

Port is open and visible. Weird thing is that 2101 as non secure works from anywhere. Lab or wan.

Hi All,   I have an ELK M1G with Omnistat.  Commands to the Omnistat work fine through ElkRP programming or through ekeypad except:   The temp display on the Omnistat itself does not show up in ekeypad, and changes made on the Omnistat itslef (to say temperature or fan status) dont cascade back...

Hi All,   Hoping someone can shed some light on how to connect via WAN using secure port.   I have a static IP on the M1XEP -  DHCP reservation for the M1XEP IP using MAC Address Port 2601 forwarded to internal IP Port 2601 is open DDNS is working properly.   It does not work using ElkRP or...