Recent content by gmiller

  1. G

    Master code lost

    Awesome thanks a lot for the info. I,ll order one today
  2. G

    Master code lost

    Does anyone know the ( short the board with a wire ) trick to reset the master code? I know it exists as i used to have in one time but i lost it. You shorted two place on the board. I think one was on the main CHIP pin 1 if i remember, or something similar. You used to be able to send the board...
  3. G

    Aux zone constantly sending trouble signal to alarm company

    HIGuys, i have an empty zone 22 ( hard wired expander zone) Its completely blank and set to AUX . But every 4 minutes or so it send a trouble to the monitoring station. I did the usual RAM reset and it was ok for about an hour and then started up again. I'm going to change out the expander...
  4. G

    PCS, creators of UPB, considering offering HAI OmniPro repair service, input needed!

    Hey there, i am a long time hai dealer with likely 100 systems out there. I have lots of parts, mostly good, but would like the option to have ones repaired if you get this on the ground. Add me to your list. tks
See more
Back
Top