Recent content by gr2659

That's the ticket. Thanks much for the super-quick reply!!

Looking for suggestions on something that I think should be pretty simple but I'm not quite wrapping my head around the "easy" answer...    Short request... I just want to provide contact closure when a 120v switch is turned on, what's the easiest way to do that?   Ideally it would be through my...

  Correct, I can enter a static IP, or change any of the settings on that page, no problem... BUT the buttons to "Reboot", "Send" or "Receive" those settings remain grayed out and unclickable no matter what I do.  It won't accept any changes that I make.

Yes.  I can ping it's default IP but ELK RP won't let me make any changes to it.   Because of your question, I loaded M1 2Go and it cannot discover the XEP.   ELK RP sees it every time (with it's default IP).  I can ping the default IP if I move my PC to that subnet and I can get ELK RP to talk...

  I didn't change where it is physically connected (i.e. same switch port, until I started troubleshooting).  I have this same problem even when connected to it with a crossover cable.  It is definitely an issue with the Elk interface.  Wondering if I can "update" the firmware even if it is on...

Hello,   I have an ELK M1 with an M1XEP connected to it.  It's been working great since I originally installed it about 2 years ago.  I've been doing a lot of expansion lately and just cleaned up my panel the other day.  I turned it off, rerouted some cables, etc.  When I brought it back online...