Recent content by Grayson5

Hi,   I recently installed the ELK-M1 and I am now looking to get into lighting controls.  Since I planning on controlling many lights I know I need the ISY994i, but my question is linking the M1 to the ISY.     I thought I read on the forums that this can be done over the network (I have the...

  It sure is!  Got the keypad mounted on the wall and the internal speaker working.  

Thanks! I was able to get the first 2 zones hooked up today and on my way to hooking up more, plus the output siren.

Just thought I would "brag" a little and say I have successfully hooked up my M1 to replace the old, non-functioning ADT system in my home.  While I only have figured out the wiring for 2 zones, I was able to use the keypad to get the initial programming done and then hooked up the M1XEP to see...

Hi,   I am in the process of installing an ELK-M1 to replace the existing (not hooked up) alarm system in the house I recently purchased.  I am pretty much an amateur when it comes to wiring and I had a question on how the existing wiring is hooked up for the old system.   Please see the picture...

John's Pictures

Thanks so much for all the advice.  I will be back home this weekend and give the approaches a try!

  Lou,   Thanks for the response.  This may seem like a silly question, but when you say "you will see what zone trips on the Elk" where does this occur?  I am assuming you mean with the RP software.  Is there a specific screen or function where I can see when a zone trips?  Do I need to setup...

Hi,   I just purchased an ELK-M1 to replace the existing ADT security system in a home I recently purchased.  The challenge I have is that the current ADT system is not active and the labeling of the wiring in the ADT control board is poor at best. I am having difficulty determining which wires...