Recent content by gtomkins

Hi Guys, Still no go so I connected directly to input 15 on the Elk set the input as non-alarm and EOL, set fast loop response (thanks for that tip work2play), created a rule and works like a treat (this definitely eliminated the pushbutton as a problem). So I can't explain the keypad not...

Hi Guys, I only have one keypad so have eliminated getting the wrong keypad. I think my last effort will be to scrub the system and keypad then update to latest firmware and see how it goes, sounds like a weekend job though. Will let you know how I go.

Just got home so I disconnected the EOL resistor and totally removed the button, so nothing connected to the KP2, still same result. I unenrolled and re-enrolled the keypad and no change, I deleted and recreated the KP zones no change. I set the input as non-alarm 16, tried EOL, then Norm Open...

Hi All, I did disconnect the switch at the connector, that is only the EOL resistor across the input which shows the same result so have now discounted the switch. When I get home from work tonight I will remove the EOL resistor and see the result, I will unenroll and re-enroll the keypad and...

That should read I created the input zone by adding new input Hardwired - Exp 13

Hi Work2Play, thanks for your quick response. I have removed cable from the switch device and shorted out the wires from the switch end, still no change. When doing this on the KP2 my multimeter shows the voltage drop on the blue wire from about 6.8v to 0v when shorted. Still no joy when I look...

Hoping somebody can help me. I have an M1 Gold and a KP2 kepyad. I connected a dual RFID reader/Doorbell to the KP2. The RFID reader works great but I cannot get the input to recognise the dorbell. I have wired the input exactly as the ELK manual suggests with 2.2k resistor between Gnd and the...