Recent content by hipertec

Hi everyone. I removed all our HAI Switches and Keypads from our home and went with another lighting system. Now I have over 100 keypads/switches for sale. Are there online sites where I can list these for sale instead of ebay.com since these are very specific? Im not sure if this is OK to...

Thank you for your advise. Ill try to reach out to Levitons Las Vegas contacts and if you can post a message for the software section, Im hopeful that would be a great help for me. Thanks for helping on that front.

Thanks for the info. My current house wiring, where all the load wires/masters (4 wire) goes to the closet and 2 wires/slave switches goes to the room, Im limited to what is available since, most of the rooms where the slave keypads (2 wires) are only have the white/black/ground wiring. I...

Currently have a home that was built in 2006 with the Omni Alarm and HAI lighting system setup. We've disconnected the setup and Im going to replace the alarm system. My issue is the HAI lighting Setup/UPB. The home is wired using the UPB setup where the load switches are in 3 closets, then...

Hate to bump up this thread but Im also in the same boat. Have the HAI lighting system, tied into the Omni alarm (which will be replaced). So I looking for a HAI Installer/programmer (ideally in Las Vegas, NV area) that can help me. Or if anyone here can suggest a cost affordable replacement...

Hi... Please see the images of the closet area where I understand the main load goes to: Then there are two wires + ground that goes to the keypads to the particular rooms but this images shows the past owner replacing this particular room with the Lutron Caseta Pico Remote: Some of...

Hi, I just purchased a home that was built in 2006. The home was wired with a HAI Smarting lighting that is not working correctly. Looks like all power load swirches is ran into 3 center point closets and two wires and ground goes to the HAI keypads in the room that controls the lights. This is...