Recent content by ibjeepin

I have a board I bought way back on ebay as a backup but never tested. Cant see phone line, been trying to draw out the chema for that section for a while. Thanks!

I am impressed with all the reverse engineering efforts here. Thanks the information provided is priceless considering Leviton did not release all of it after discarding the line.

worked for me! Thanks

Ok so it seems that this board purchased a week ago was not flashed to current. I did another check for updates and it downloaded the flash file which I then wrote to the board taking about 40 minutes. Why would HAI use the slow serial port? On first reboot it came up with a bad mac...

  I have never seen any other behaviour other than the window closing after hitting OK.   Thanks Mike

Another thing I cannot do is set full or half duplex etc as it can also be an issue with certain switch / nic combinations.

I used the short one that came with it. Based on the internet it is a rollover. I pinned out the connections with an HP multimeter. I really cannot believe Leviton does not allow you to configure the TCP/IP setting in the software like all other manufacturers do. There is no way to tell what the...

I too am having issues with the setup and verification on my notifier board. I have an OP2 and is a 3 serial port unit with 3.13 rom in it and running 1105w software v3. For the life of me I cannot get it to send email  Everything looks good but its a no go. Checked serial rollover cable and it...