Recent content by ja02333

I adjust the timing to 15us and the sensors that would not work, now work. I have a total of 8 sensors connected and the are all working. Thanks for your interest in resolving the issues and giving suggestions to try.

the sensors I have with the 00's work and I have 2 of them working. The sensor with the 15 will work only by itself. When I add more sensors the 00's work and any that do not have (00) in the last 2 do not work

I just tried to add a senor that has never worked with this board. When looking at the serial number for a sensor that works I see the following using a (Raspberry Pi) 28-00000540979b When I look at the serial number using the Web Control8 I see 289b97040500 00   The sensors that I have that do...

Downloaded the 1/26/16 file and the temp sensors are now working. Thanks for the help. If this board is not subjected to a high ambient do I need the rework? It looks like this board has a rework (Stacked) components on location R13. (cap on resistor)

I have not sent the board back. I downloaded the file from the link from this discussion. The copy that I downloaded had a date of 1/21/16 4:35 PM (3-3-25) I still do not see any of the sensors. I will send the board in for repair/ evaluation Thanks

Thanks for the offer to check out the board. I can send a sensor along with the board. I also have a sensor that has never worked with this board but works with another vendors board. I thought it might be the Amazon sourcing or quality oh the sensor not your board. Please let me know how I...

The board revision that I have is 2.3.7 I have loaded the old version and it works, I see all sensors and get the correct temp. This board will never see 50C (room temp only) I might bring a scope home from work to see if there is data on the yellow lead with the new version. Thanks for getting...

Thanks for you assistance. I purchased the sensors from Amazon  (Vktech DS18B20) I only have one board. If there are no major improvements with the new release I can use the v03.03.23 version for now.

Tried the download from the site, installed firmware, still do not see the 6 sensors, all sensors are on short cables around 3 ft. Board settings tried 3 and 5. All sensors show all zeros and no sensors are shown during the selection settings. v03.03.24 removed all but 1 sensor and still do not...

Tried new firmware and none of the sensors are working. Replaced with old 30323 firmware and read temperature from the sensors