Recent content by jeffreycowart

I am in the process of installing an ELK system in my home.  The M1 panel will be located in a basement closet out of sight, but I was wondering what happens if a keypad is smashed or ripped off the wall by an intruder during the entry delay?   This would potentially short out the data bus if...

Alarm Relay recommended the IP Datatel CDMA Cat or Bat to me (cheaper monitoring). The Cat is cellular only and the Bat is IP and cellular. I just installed this and it could not have been easier. I don't have much running on my Elk M1, so I was able to power the CAT directly from the Elk to...

TurboSam, Thank you.  I know it sounds silly, but I am still learning to use the search function...  I searched for 2+ days for that answer, but I always broke sensorswitch into 2 words.  That post will not show at all with sensorswitch as two words.  I even just tested searching for "sensor...

Happy holidays everyone.   I ordered a few Sensor Switch CM PST 9 R (with relay) Occupancy Sensor to connect to an Elk M1.  I have bench wired one up and it works as expected using the relay going into a normal zone.  There is an audible click when the relay changes state.   I thought that I had...