Recent content by jlaronde

Just thought I'd update everyone on the issue.   Seems I had two issues.   1) The HAI PIM was faulty. The PIM could transmit commands to control lights, but could not receive, so light status could not be updated. 2) Several of my switches were faulty. Similar problem - they would receive and be...

I'm actually using HLC mode. Everything worked fine before the upgrade. After upgrading the firmware, the OmniPro II was erased, and I had to upload the saved settings from PC Access. I was thinking that something was reset or changed that is not stored in PC Access. On a side note, do you...

Unfortunately I don't have the cable and adapter to use upstart (currently on order). I've tried downgrading back to version 2.15 but have the same issue now with the 2.15 firmware installed. Is there any settings in PC Access or through the controller itself to enable status reporting? I've...

Need help... I recently purchased a home with an OmniPro II System installed. The system was installed approximately 5 years ago. The system has pretty much run flawlessly. I recently replaced a non-functioning temperature sensor and upgraded the Firmware (from Version 2.15a to Version 3.11) to...