Recent content by kb5ynf

I'm pretty sure I don't have an infinite loop issue but I'll double check to be sure. And no, cycling power doesn't fix it; which would seem to support my previous statement. I'll do some more testing to see what I can figure out. I just checked my programming and I don't have anything setup...

I'm not triggering off the alarm. My normal daily automation stops working any time there is an alarm event for some reason.

Hello: I have an OmniPro II. Installed it four years ago. It mostly works as expected but for the last couple of years, anytime someone trips the burglary alarm (which my wife tends to do on at least a monthly basis), the programmed automation stops working. To get it working again, I have...

Okay, I finally found time to really work on the reason that PC Access 3 wouldn't load at home. When it installs, it creates a folder in My Documents, which for me is located on a network drive. I have offline files turned on but sometimes folders don't sync for whatever reason; the HAI folder...

I checked PC Access 3 at home this morning; I'm adding some new sensors and needed to program them. Well, for some reason it still crashes immediately whenever I try to run it from home. Again, this is the same PC as I use at work and the only difference is that I connect to a wireless network...

Well, so far this morning, it looks like 3.0.0.455 has fixed my issues. I've been connected to the controller for going on an hour now with no problems. I first let it sit idle on the setup page for several minutes and it didn't crash. Then I began making some changes to the setup, codes and...

Okay, I watched the clock for several minutes without the app crashing. Then I switched back to the setup page and it crashed two minutes later. Does that help?

Ha! I think you're on to something. I did as you said and it's now been on the status screen for over four minutes without crashing. The clock is ticking away like you'd expect.

Hi Fred: Thanks for the response. On the flashable/non-flashable question, I kind of figured that was what was going on there. I'll have to check the control board to be certain but from the info you provided, I think mine is non-flashable. As for the app crashing, it crashes no matter what...

Well, tried PC Access 3.0 from home after church and it wouldn't run at all. As soon as I tried to start the app it would crash. Makes me wonder if it's maybe a network issues since that's the only difference in my setup between work and home (I carry my laptop home with me and work from...

I know this thread is a month old but i just upgraded to PC Access 3.0.0.452 and it crashes every few minutes. I'm running it on a Vista Business laptop; PC Access 2.15 runs on the same machine flawlessly. So far I haven't noticed any pattern to the crashes, they seem to occur no matter what...