Recent content by lupester

I entered the code and it said "Alarm Acknowledged" again. Then when I push the up or down key it says "No Zone Violated". No alarm shows up in the log.

Actually last night I disabled all the glass breaks and motion detectors so the new sensors should not matter. I will check your recommendation about putting in the code again.

My M1 has been working fine with hardwired and wireless contact alarm zones. I have added 3 motion detection/glass break sensors. Each sensor has 2 zones....1 for motion and 1 for glass break. I think i have configured them correctly because the motions only get monitored on away(exit) status...