Recent content by mjs

I'm not by the panel now so can't send a photo, but I programmed the HAI controller via the panel. It sticks every time i change it so pretty confident that it's right. I've even rebooted the whole HAI system after setting the IP, still no ping. If the ethernet port on the HAI controlller is...

Thanks. I've tried all of the above and still not ping'able. I tested continuity of the cable all the way to the HAI board, and it's good. I guess it might be a hardware / NIC issue. Two remaining questions: 1.) when i connect directly from my laptop to the HAI board, I should use a cross...

I just changed the DHCP IP pool to start at .4 and end at .249 because I was testing if the OP2's IP of 168.1.3 or xxxx.1.250 would work; neither did. Everything i read says to keep the OP2's IP within the subnet, but outside of the DHCP range.

... no luck. I tried xxx.xxx.1.3 and same result: "Destination host unreachable"

I'm new to networking but trying to learn, so appreciate your patience. My understanding based on some Google searches and ChatGPT is that with a router IP of 192.168.1.1 and a subnet mask of 255.255.255.0 my your network contains: Network address: 192.168.1.0 Usable host range: 192.168.1.1 –...

Hi Pete, I've read through many of these OmniPro II connectivity posts, trying to figure out why I cannot get Snap-Link to "see"/connect to my OPII controller (UnableToOpenSocket error). Hoping you can help. Here's where I'm stuck, and a summary of what I've tried: 1. When I ping the OPII's IP...

My HAI OmniPro II system just suddenly stopped answering / picking up when i dial into the system from the phone. I do the typical dial, hang up, wait 6 seconds, dial again, and when i get the beep, i enter the security code (as i always have), but then instead of hearing the voice attendant, i...