Recent content by mlefevre

Sorry, I've been consumed by higher priorities for a few days.  Thanks for the suggestions.  Yes, I can control the switch from PC access and the OmniPro II.  To answer neillt's question, when I actuate the switch, the status is NOT reflected in the OmniPro II status display.   So, to summarize...

The switch is one I just installed but it is configured for HLC and not UPB (I have PC Access).  When I monitor the switch in the Status/Control tab adn switch the light on manually, the status for the light does NOT get updated.  So, I guess I should have looked there first and concluded that...

Here is what I see in the log for a press top (on) followed by a press bottom 3 seconds later:   2,05/05/2013 22:30:46,2/2,84,State,1,Unit 001 - Stairway - Stairs,,0,,,100 1,05/05/2013 22:30:46,4/4,84,Indicate,255,,,-2,[multiple receivers],, 1,05/05/2013 22:30:48,4/4,84,Indicate,255,,,-193...

Desert_AIP: I've been trying to figure out how to do this in upstart but can't.  Could you give me instructions please?   Thanks, Marc

I'm trying to do some programming to automatically turn an HLC light off 10 seconds after it is turned on.  Here is the automation:   43.    WHEN Stairway ON PRESSED             THEN Stairwell light timer ON FOR 10 SECONDS 44.    WHEN Stairwell light timer OFF             THEN Stairway OFF  ...