Recent content by padamson

  Poll was a poor word choice.  I wouldn't poll with my HAI automation program, the Leviton Controller would, just like a MiCasa Vera or InControl SW Controller does.  As DrvnBySound noted, if the device supports the Z-Wave Instant Status, the HAI should know about it.  Intermatic and GE...

Yes it does seem like overkill to replace every switch in the house.  But my current plan is only to replace the UPB switches which control (via half-hot outlets) appliances throughout the house stereos, wifi, re-circ pumps, X-mas lights, attic fans, etc.  Using the HAI I can kill ghost loads...

I have a lot of LED and CFLs too.  The VRI06 Levitons actually work fine with the LEDs as long as there is more than 40W load.  There is a hum, but it is very faint compared to the GE/Jasco dimmer.   That link to the HomeSeer page is great! I had started filling out my own table, this saves me...

Clarification on my UPB panel problems: re-reading my last post, it sounds a little confusing.  Using UPBStart I can see all UPB devices on the panel that the UPB Interface is plugged into, but not any devices on the other panel.  Devices on each of the panels show signal loss, so it could be...

OK.  An update on things.  My Leviton USB stick arrived today and I redid the entire network (excluded all devices to clear their address and them included them with the Leviton Vizia RF Installer tool).  et Voila! The HAI could control all the switches.  However it still did not see state...

New member, tried this same msg on the HAI Forum and got crickets (no answers).  I have a 8yr old HAI OmniPro II system that I installed, working perfectly with Compose Lighting and UPB switch controls.  Unfortunately Compose has been EOL'd (and I'm running out of spare parts) and HAI cannot...