Recent content by paulrichjr

OK so thanks for the help.  When I went to the ELk site (on this board) that you linked I immediately went to the sticky links and at the end of one of them I read this...   July 9, 2012 - SUNSET of support for Caddx firmware version (M1 Firmware 4.6.8) Announcing the Sunset (end of updates) of...

OK so right now I really am starting to hate and I do mean hate Elk.  I called to ask if theM1XRFEG  firmware would work with the m1XRF2G and the person said it would not.  I then asked about the blinking going on and the answer I was given was "we can't help you with that..."  Really?!  You...

Ok so I tried to upgrade my firmware but couldn't.  I have an Elk M1xrf2g instead of the m1xrfeg.  Does anyone know if that uses the same firmware?  If so how do you get it to work because the latest firmware will not go on it...It doesn't see this firmware.  The lights on my unit blink orange...

I have had this unit almost since it was first released.  In the past I have had a GE wireless motion detector near the entrance of my driveway that would start different automations with lighting if the system was armed....   Anyway, my motion detector broke several months ago along with...

I have an Elk M1-Gold with Insteon 2413 controller and XSP. For at least a couple of years everything worked fine until my former controller (I think a 2412) went out. I purchased the new 2413 a couple of years ago and have never gotten some of the automation (involving my garage doors) to...

Actually I do have it controlled by a single x-10 command. First of all no one knows that I do that so I'm not real worried about someone being able to figure it out. Secondly, if they did break into the garage they couldn't get anything since I have nothing in there except junk. Third...I...

I am using a PUM01 from X10 I just plug it into the same plug that garage door is plugged into and then take a wire from it and wire it into the same holes as the door buttons by the interior door and set the x10 code. I then have my elk close the door during the daytime if the door has been...