Recent content by payele

Yes, I agree that it should be, but it isn't.  I'll try rebooting the controller and the retrieve data.  Its shows the heating side, but not the AC side. It does look exactly as your pic in PCA, but its an extremely old controller.  I think it was running 2.1 or something for firmware.  First...

I'll try all that when i'm next on site, but has anyone every seen the AC controls not appear on the App?  The wiring is fine, I know this because it has been there for 10 years working trouble free.  I'm not understanding why the heat controls appear on the app but not the AC.   When I called...

The Omnipro II panel is an old one.  I had to upgrade the firmware by replacing the chip, so its 4.0B now. I haven't checked the physical wiring at the panel yet since its an existing setup that worked for years, but his older style omnistat died and I replaced it with a new Omnistat RC2000.  ...

Hi All,   I'm sure there is a simple reason for this, but i've just a chip firmware upgrade for a client so he can have app control, but for whatever reason,  when you click on the thermostat, it does not show anything for the AC.   I tried the setting the t stat to AC and it doesnt have a...

Yes, I've considered noise from another pair as I am carrying the AB in the same Cat5e.  What is unusual (to me at least) is that the temp reading does not vary.  Its been the same since I installed it a week ago yet outdoor temp has varied by 20 degrees.

Hi,   I have an Omnipro II setup for my property and recently added an expansion enclosure for my shop - a separate building about 20' from my home. I ran underground PVC conduit with multiple data cables, one of which is connecting an Extended range temp sensor.   I have power for the sensor...

Hi all,   Project I have uses about 90 z wave nodes, mostly vizia dimmers, switches, scene and zone controllers with an omnipro II controller. While everything works less the scene and zone controllers which take forever to get a command right the few times they respond, the Leviton usb stick...

Thank you, turned out to be a typo in the IP.  All good except that I had to downgrade firmware from 1.8 to 1.7 to prevent the screens from restarting every time I access a camera.   Do not upgrade to 1.8!  Its very unstable!

Hi all,   I have an Omnipro II installation i'm wrapping for a client that has gone quite well considering how complex (for me) this one is. The problem is that the 6 vivotek 8000 series cameras will not come up on either of the 2 touch screens.  All I get is a black screen which claims to be...

I have project where the customer would like to have his doorbell integrated into the system and have an intercom. It seems redundant to go with an OnQ system when we already have an Onmipro II, but I haven't seen this application before.   Any ideas??