Phoenix1701's latest activity
-
PPhoenix1701 replied to the thread Omnipro II, PCAccess, Snap-Link.Here is the new printout from PCA. What is Upstart? Now I understand of getting a USB to serial cable adaptor, then that would connect...
-
PPhoenix1701 replied to the thread Omnipro II, PCAccess, Snap-Link.J1 is the wide flat wire going to the UPB plug that goes into the wall outlet. If we have anything on property that is uses it, I don't...
-
-
PPhoenix1701 replied to the thread Omnipro II, PCAccess, Snap-Link.Here is where they both go to. They are just bunded together, not sure what to do with them or how to use them. Also there was a line...
-
-
PPhoenix1701 replied to the thread Omnipro II, PCAccess, Snap-Link.This is panel EE1 after I hooked up the relays
-
-
PPhoenix1701 replied to the thread Omnipro II, PCAccess, Snap-Link.Individual lines - 117 in the program printout, 41 groups of commands.
-
-
PPhoenix1701 replied to the thread Omnipro II, PCAccess, Snap-Link.This is part of the automation. Does this look normal? and this is the list of relays/panel location. I can't figure how to get into...
-
-
PPhoenix1701 replied to the thread Omnipro II, PCAccess, Snap-Link.Ok. That is a start. Now how do I find and adjust some of the relays in board EE1-5, 6, and 7 relays that they are on all the time...
-
PPhoenix1701 replied to the thread Omnipro II, PCAccess, Snap-Link.I have a printout of the automation. Now if I change a setting in the automation, will it be automatic or does it have to be saved, and...
