Recent content by Powox

Hi,   (sorry for my english, i'm french...)   Until now, for the KNX, I was using a KNX / RS232 gateway. But I can not find any more. What do you use now? I have not found any IP / KNX drivers ... Thank you   Jean-Michel  

Hi chucklyons, I develope with premise since 10 year now. but this soft do not upgrade. I will continue to use Premise, because i can control my house with my iPhone and that i like this soft!

Hi, I'm French and I'm verry interested to see premise in open source! if one day motorola agrees to make the code public, it will be very good news :) Jean-Michel

Hello, I'm french, from Paris. I develop under premise systeme, objective-c and flash to create user interfaces to control their house I also use Pronto, RTI, KNX, Nevo, ActionScript, PHP... Jean-Michel

Not enough disk space ? I Have had a problem of disk space. few kilo octets only... But, premise has rewrite the main XDO, so to write, premise has opened the file and ... not enough disk space to rewrite and close the file... consequence : soft reset... Jean-Michel

Hi, I don't know if this software can integrate with premise, but I know that the enterprise wich has developed ExDomus has used "Premise" in few another installations. The Enterprise is DHC (Digital Home Concept : http://www.digital-home-concept.com/ ), It's a french enterprise. Otherwise...

Maybe ex-domus ? http://www.exdomus.com/ this enterprise has work with premise during long time! Jean-Michel

Hi, I also think that the version is sent by the device. I Can check tomorrow if the version of GC's are the same in all installations. The problem is very recent, so, maybe a bad serial of GC... In the network, nothing should disturb the GC's. I have less of 10 devices on the network and each...

forget this, I have another customer with a version 1,3.2-12... I don't understand :( je ne veux pas ecrire un driver :(

Hello, I has been in old forum, yes ;) but I have not resolve my problem yet :( but my version of is : getversion,1 getversion,1 version,1,2.0.7.071503-1-12 and etc6849, you have version 1.3.xxxx where is the driver for this version ? Jean-Michel

Hello, It's just a classic GC-100, not an iTach. Tomorrow, I can try your solution and see the events log. Thank You Jean-Michel

Hello Sinci few months, I have a problem with few Global Cache. Several times by day, the Global Cache Driver write an error in Monitor / Events. During few minutes, the global cache is not accessible. I don't know why... I have change Global Cache I have change the power supply I have change...

Here is the code I use with "RxText = true"on onNewData : dim arr arr = this.RxBinaryData Dim I, S For I = 1 To LenB(arr) hexaCourant=Hex(AscB(MidB(arr, I, 1))) if len(hexaCourant)<2 then hexaCourant="0" & hexaCourant end if S = S & hexaCourant & " " Next this.RxRemoveBytes = LenB(arr)...

and if you use hexa mode ? do you have informations in case "RxBinaryData" ? I use rs232 to received a watchdog from an audio/video matrix ("02 53 53 53 03 ") and I have no problems Jean-Michel Rendu

Hi! myyaz33 : I think that it's possible to do an "eval", yes, but the script can check other drivers (with little modification). If you have a drive "D", "E", it can check these drives too and send an alert. But it's true, make a boucle for one occurance is a heresy 123 : ex: if drive C not...