Recent content by recoon

Today I connected a second temperature Those switches like this http://www.ebay.com/itm/281098385021. Those switches are connected in parallel with a conventional chip DS18B20 enshrined in the contacts on the board. Those switches are both uncertain, but indicate the temperature by 2 degrees...

Thank you for the nice words. I still have enough questions, but they are related to other topics. For example as podklyuchet relay? I will begin to study the forum. If you can not find answers to your questions will be asked. Thank you all for such a scientific society.

You were right. I replaced the power supply on the one that really shows 9V to contact LM2940S issued approximately 3,5 V. Wired to the router and the first time entered the WebControl. Thank you for such a diligent support. Question on AC power supply 9V. What should be the minimum if I'm going...

It's unpleasant to know that something is damaged. I applied to the board voltage 9V recommended in the users guide. I measured the voltage at the terminals LM2940S it was about 7V. Here's a picture with the measuring points http://yadi.sk/d/MOsqTKwJ6RWjf By WebControl nothing connected except...

Now I bought a new patching cord and connected to the router WebControl. Green LED on the board first blink frequently. Then the left LED on the network connector starts to blink. Green LED on the board flashes are not very frequent. The LED on the router also blinks about once every 2 seconds...

I am using Windows XP. Today I tried again to connect the mains lead WebControl and not all of the indicators light up. Maybe I failed patching cord. Typing in the browser 192.168.1.15 I do not see the window with a set of login / password.

    Thank you so much. Yes you are right green LED is lit and the yellow flashes in the time of the request to the address 192.168.1.15 only twice. Then after a while and goes green at this point page shows inability to connect. After that lights up green again and krtkovremenno flashing yellow...

Fortunately board found a scanner based on IP. See screenshot http://yadi.sk/d/y6KLE6RF6OdN4 But I still can not get out on the WebControl through a browser. Also, do not ping through the terminal. It looks like something interferes. Tell me what can it be?

Fortunately board found a scanner based on IP. See screenshot http://yadi.sk/d/y6KLE6RF6OdN4 But I still can not get out on the WebControl through a browser. Also, do not ping through the terminal. It looks like something interferes. Tell me what can it be?

Many thanks for the elucidation. I connected to the router WebControl direct power cable.   The yellow LED on the module and the LED on the router.   On the computer IP 192.168.1.11 the router is 192.168.1.1 The module is still not pinged. DHCP is disabled.   How bruzerom better use? I have a...

welcome Connected to the power supply module WebControl 9V. Immediately the red LED lights up and blinked green. Wrotham connect RJ45 network cable, but there is no connection. Indicator lights on the connector does not light up. The module does not ping. Tell me how the wire should be connected...