Recent content by rkotara

  Just had this happen to me.  I think a power event that happened a few days ago put it to this config.  I set my PC to the 192.168.3.1 address and told the RP software to connect to the device at 192.168.3.64.  Once it connected I changed it back to my desired IP but I have the same MAC as...

  To get this fix I suppose we have to mail in the board to get it flashed?   Ray

Ah, most of that will work for me except I dont have a RFID relay board (YET!) and just use a magnetic switch to detect position of garage door. I want to auto-close and/or web control close it when necessary. I'll work with that and see if I can modify it for my purposes. What RFID setup do...

I'd like to do this as well but unfortunately, my garage door uses a "smart" wall console. Shorting the two wires does not open the door. Its a Genie IntelliG 1200 and the wall button has 3 buttons over a circuit board. How can I tell what it is doing and emulate that? I'm pretty new to...

Thanks for the tip! Picked several up at Altex here in San Antonio. Does anyone have a pinout already made for the ribbon cable? Maybe I'm being too careful but I just didnt want to go testing my theory that the cable goes 1, 16, 2, 15, etc... without knowing if that is correct.