Recent content by smoov

Following suggestions above about combining sensors into zones, I think you are OK with just the kit. The M1 has a serial port on the panel for connecting your PC. I had to get a USB to Serial converter to use my laptop that doesn't have an old school serial port. Good luck with the retrofit...

Thanks guys, that is exactly what I wanted to do. Have the strobe run continuously until disarmed. This is for a small retail store, but I will do the same for my home M1 when I eventually get around to installing it. Also going to automate turning on all the lights on alarm and disarm, etc...

I have 2 PIR's and 2 GB's and the NX-702 on 12VDC Outputs (left side), nothing on Outputs 7-16. Elk-73 on Output 1, nothing on Output 2 or 3. Output 2 has a 2.2k resistor across it. I was thinking of running the strobe on Output 2, set to voltage, but wasn't sure about which wire to use. I...

Thanks Spanky. I think I'll let the NX-702 ride for a while. It is on the main entry/exit door in a retail space, with chime on. We will know right away if it doesn't work. Also, I will plan on replacing it with a more appropriate receiver when I make my next order. Any wisdom on wiring up...

I posted this in the Hello World forum, but it might get more notice here: I have an Elk M1 Gold system and am looking at the Caddx NX-702 - Quik Bridge non-supervised 2-channel receiver for a quick and cheap way of adding wireless for the two doors I can't hard wire. I haven't found anyone...

Hey found this site while researching Elk M1 products for installs both in my house and retail business. At home I'm replacing a proprietary Ademco Vista 15 or 20, forgot which and for the business it is a new install. About 20 years ago I worked for an alarm company in an inner-city area for...