Recent content by sowhat

yeah, you are probably right, but I can use tampers anyway, only system won't distinguish movement from tamper opening. Now I have new problem, please pay attention to may previous post.

Latest news: I changed zone type to 6 = INSTANT - This zone creates an instant alarm whenever it is tripped and the Armed LED is on. And everything works fine except one thing - system reports "Service required, Type *2 for help" And *2 reports that zone 14 is tampered. How to take away...

here you can take a look at NX-8 install manual. Zone doubling is very cheap way for extending your panel ;) As I understand in my wiring, there should not be any difference between cutting detectors wire and opening detector, because tamper contact resistance is so small (0.01K). Default...

yes, they both are on channel 6. Zone doubling enables adding 16 detectors to 8 chanels ;)

thanks for replay! I don't know resistance levels B) they aren't mentioned in users manual, but I will measure what I can. So here it goes: No movement: 2.73K Movement on zone 6: 3.66K Movement on zone 14: 6.70K Tamper open on zone 6: 6.72K Tamper open on zone 14: 3.67K here is a little...

why nobody helps me? :) B) :(

Hello! I am really stuck for few days on trying to add ninth detector to my system in the garage. I connected new detector to zone 6 and replaced old resistor with new one 3.74K for doubling and also added one more resistor 6.98K in the new detector. Turned on zone doubling and selected zone 6...