Recent content by sqhughes

I ordered the same sensor with an RC-2000 stat. Here is what I found out. The only way to connect that sensor with an Omnistat is with an optional interface (part # 65A12-1). The only problem with that is the optional part has not been released yet (at least not as of last month when I tried to...

I installed a M&S dmc1 several years ago and still use it to monitor my kid's rooms and for whole house audio/announcements with Homeseer.

Excellent! I'm a big fan of Blade Plugins and have had my Brultech monitor installed for several weeks now. I'd volunteer in the beta testing if needed, but I didn't see anything on Blade's message board about this yet.

I have the same problem with a M1RB. One relay stayed on all the time, while another would never turn on. Haven't had much time to do troubleshooting yet, but like you, I moved the devices to another output.

Is there a cocooner discount code?!!

I'd like to give it a try. Scott

I actually had a couple of switches with the paddle problem that were out of warranty that SH replaced. No charge for shipping either.

Thanks for the tip. Just ordered my free module and since I was already paying about 10.00 for shipping, I added a screw in z-wave module. Shipping price didn't increase with the extra module.

Joe, I'm doing exactly what you described with 110V for a hot water circulator in my garage. I also use the relays to control my exterior low voltage lighting. I was thinking about using an Elk relay to trip the reset switch on my Homeseer PC. Scott

Did I miss this deal? Scott

Dave, I'm on Time Warner Cable in Cary and I access HomeSeer (port 80) regularly without any problems from where I work near RDU. I think I did have to open the port on my router, but it wasn't a Time Warner issue. Scott

I have the M&S DMC1 Music/Stereo/Intercom. It is hardwired using CAT5 cable. Scott

It works perfectly for me. I have my HomeSeer PC audio output hooked up to my intercom Aux input and use is for announcements, music, etc. Scott

I guess I should have taken some pictures during installation, but I was anxious to see how it looked in the wall. Here is a shot in the entrance to the bedroom: Close Up: As for the installation, I drilled a 1.25" hole in the the floor between the studs to run the power, USB, and video...

Got mine today. Got it installed and it works great. All I need is a bezel to finish it off. Michael, are you going to put these up for sale again? I might order another. Thanks, Scott