Recent content by t_garp

Ok, NOW I got it to work! Hallelujah!!! The problem was that I had the B&B RS-232 adaptor coneected to the keypad input (This is the converter required for an ELAN home systems touchscreen to interfacr with HAI) however, I did not yet hook it to the ELAn and it was just randomly on...

OK, I checked the wires and all appear to work...The kay pad displays the time and date and say System OK. If i try to press any action key or to arm the system, It says Enter Disarm Code while beeping 3 times per second. It is at this point that the key pad becomes unresponsive and does not...

I have seen the No Controller Data00 Message, but only after I try to change a configuration, such as changing the keypad's address. I only have 1 keypad installed. (I am going to test all the wires again today). The keypad beeps thre times per second constanly! As for barely accepting...

Thanks for the suggestions above, however, no dice. I can access the setup menu from the keypad no problem and set the keypad adress to 1. If I try to arm the system or do any other action, it just keeps beeping like crazy and does not accept my code inputs...This is very frustrating...

HI guys, I've tried everything and I can't seem to get my keypad to respond to any inputs. Everytime I try to press a key on it, it says enter code and I enter the default code "1111" I even tried the Master code I entered into the software. It barely accepts my inputs, I try to enter a...

Since youre in Van..you should check out mControl. It is an automation plugin for Windows MCE. They have also developped their own touch panel, the mPanel. The guys who developped it are in Surrey. http://www.embeddedautomation.com/EAHAMain.htm I personally went went with an Elan system + an...

I ended going with 2 HAI RC2000's. Automated outlet had them for $248 each! I will probably need other thermostats in the basement for the electric baseboards and i liked the fact that I could buy the lower end HAI models and keep everything the same brand. (don't think it makes a diffirence...

HI all, After lots of research, I have decided to automate my new house with an Elk M1Gold, OnQ ALC for lighting, an Elan S8.6 & V883 plus touchscreens for A/V. My HVAC guy does not sell communication thermostats, so i was wondering what should I use? House split into 2 zones. I have a 2...

My electrician is installing 2 1/2" deep boxes, is that enough? I guess the 600w dimmers I need are these ones. 363143-01 http://www.onqlegrand.com/jahia/Jahia/pid/1093 Not these ones one the Setnet site... 363143-11 http://www.onqlegrand.com/jahia/Jahia/cach...DA6B212210423D5 talk about...

Hi, I have decided to go with the OnQ ALC system in my new house. I am planning to run Cat5e to all the switches that I would like to control. I have a few questions though in the best way to do it. Should I homerun all the wires to the basement? Or shoud I use the hubs to wire 9 switches...