That in my opinion (and I voiced it to ELK) has been a big hole in their system.
They have delved into Home Automation yet they say that the alarm system is their main focus.
Silly, since the future has always been in the automation part.
The fact that there is no (IF) (AND) (OR) statements...
Hello,
A big difference is that the HAI offers an "IF" in their statement where the M1 does not.''
Basic programming 101 should contain
IF (this) THEN (that) ELSE
or
IF (this AND that > that and this THEN that ELSE = that
or (we can use the OR as well to really create a professional...
Hi,
That was a great help.....
For now I have the one room with 4 sets of lights with 3-ways on each and combined as an ALL Room scene.
It is easy to activate the ALL for the Off. Is there a way to write it so if any of the lights are on, it would ignore the output so no counting would start...
Hi,
I have been looking around for quite some time now so it is time to ask.
Using Insteon w/ISY 99i and Elk M1 Gold
Trying to set a rule or rules so if anyone left a light on and there is nobody in that room, the lights should be turned off.
If there is motion, then it should wait until no...
Hi,
Been using monoprice for a while now.
I have not had any issues with anything from there and the pricing is great!
As always - shop around but I do many through their site.
epinions.com is a great tool for pricing options..
Hi,
I was hoping to create an easy setup and interface with ELK-M1, Insteon (via ISY-99), HAI Omni-stat2 thermostats and ir components connected through a Global Cache -12.
Homeseer was ok but crashes too often.
So far it seems the Premise is ideal except for the available options without...
Hi,
Thanks... I wasn't able to get to the system so no connection was possible.
I dragged a pc to the elk and connected the RS232. The Firmware was gone so I reinstalled it. All is ok now... Thanks
Hi,
The Snd/Rcv is grayed out. Is there a way to connect other than with the usb/RS232?
How about through the phone jack just below it?
All the RS232 connectors I have are female which makes perfect sense since "systems" like computers all have male connectors on them,
so it is not logical...
Hi, Spanky
The system did not complete during the firmware update to the latest for M1gold.
The keypad #1 (only one hooked up so far) says “Lost Commâ€.
Can access the Ethernet module and RP connects to that but going to the control panel it is a no go.
Please advise…
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.