Recent content by techrecruit1

I have an omniproII HAI system with a variety of diff dimmers and relay switches. I've been configuring and writing scripts with PC Access for about 2yrs now and never really ran into any problems getting the system to behave as I want. I've never really done much in way of Flags but after...

Yep it must be fried. When I click the lights on it says their on within my H@me app and same thing with off. The system thinks it's obeying the commands but its really not. I talked to HAI support and they want me to send it in.

Good to know Fred and thank you for taking time to contribute to my question :)

Thanks - I checked to make sure no breakers were tripped and there wasn't. After I did that I went ahead and flipped the Kitchen breaker to off and then back on about 2 seconds later. Should I try that again and wait 10seconds? If I do it for 10seconds and you say it resets the switch will I...

I think i posted my issue in the wrong spot earlier. I'll go in and try and delete it. I've got an HAI omnipro II system with all HAI dimmers and 15amp relay switches. Things have worked fine for 1.5yrs and I use PC Access for configuration when needed. There was a wind/rain storm at my house...

I've got an HAI omnipro II system with all HAI dimmers and 15amp relay switches. Things have worked fine for 1.5yrs and I use PC Access for configuration when needed. There was a wind/rain storm at my house yesterday and all lights to the house dimmed a little bit once or twice but never really...

Controller - HAI OmniPro II 3.2B SW - PC Access v. 3.5.0.583 Location - Zip Code 77318 (North of Houston) My system isn't keeping up with the time change recently and isn't accurate with knowing if it's day or night. I went into Setup then Location and went to the USA Flag and typed in my zip...

Yes I'm pretty sure it's all UPB lighting. In regards to the lighting format when I use PCaccess and look under units it has everything listed as HAI Lighting. The unit #'s for the rear lights that the scripts won't control is #57 is labeled as Dock Lights is RM8 then under that I have #58...

Thanks Brian, I wrote this script and still having the same problem. ========================================= When Front Entry Way Door to Foyer NOT READY AND IF DARK THEN Dock and Stairway Lights ON FOR 5 MINUTES THEN Front Yard Landscape Lights ON FOR 5...

I ended up going ahead and installing a 15a relay switch for my outdoor landscape lights and enrolled the switch and I can switch the lights off/on with my iphone and also with Windows Media Center but for some reason if I write a script in PC Access to trigger the switch it just won't actually...

message me for a sketch diagram of my offending switch and lights. I'm guessin that since i'm new to the forum I can't post a link to the image/sketch

My current HAI setup in a nutshell: OmniPro II with a variety of 600w dimmers and Aux switches used on internal light switches throughout the house (prob around 12 switches). I use PC Access for configuring and am about 2 months into learning the system and feel that I’ve learned a ton in a...