Recent content by TheLightKeeper

Add me to the list.

I also looked for something similar for using Zigbee, but couldn't find it, so please post if you have seen something like this for Zigbee (rs232 device accepting ascii cmds is preferred). ColoradoVnet has an RS232 to IR and RS232 to Zigbee interface module I think will work. I have not tried...

ver 2.1 Build 15117, the last published update.

Thanks for all the suggestions and I have tried all of them without any success. I have UPnP up and running on both the server and builder programs. All the ports are checked under the UPnP Framework. I tried using the Internet tab in builder with my IP address (192.168.254.1 and also...

123 I see nothing in the "Connect to Premise Home Control Server". I am able to ping the server. I need to look into the UPNP settings. If I can find them. Thanks, Matt

The server is 192.168.254.1 / 255.255.255.0 (fixed IP address) Builder is 192.168.254.68 / 255.255.255.0 (DHCP) Gateway 192.168.254.200 / 255.255.255.0 Workgroup is same for both computers.

I have used Premise Systems for over 5 years. I just purchased a new house and installed Premise on a new computer, new operating system and the house has a new local network all hard wired. My builder program can not see the Premise server on the network. Premise server: P3, 1G, 1G memory...