Recent content by Tunaman

Drvnbysound, thanks for the response, and the tip on Alarm Relay.   Unfortunately, I live in an area with very poor cellular coverage, and to make matters worse, I'm close to the bottom of a hill on the 'dark side' of the closest tower.  But the good news -- my broadband is extremely reliable.

Hello all. I recently had a lightning strike that took out a lot of hardware, including my next alarm ABN.   So now that I am forced to replace it, it brings up the question.  Does anybody know if there are any good options for IP monitoring?  When I talked to next alarm this morning, they told...

Most of my logic resides on the ISY, with exception of time-based events. For example, I have a series is scenes that are based on a timeframe, I. E. Pre-wake, wake... On the elk, I use custom settings to set the time I want to fire them, and matching rules that fire based on the custom...

Latest non-ul rated version (5.2.8 is also non-ul rated) is 5.2.10. I've been using that for about 6 months without any issues.

Before isy came out with there elk module, I was using this feature to update some variables on the isy. I don't remember all of the details, but i do recall it being very finicky to set up, but i was able to make it work. However, now that isy has the elk module, I no longer use this.

Actually, you can if you have an M1xep. See "Send ASCII String to IP Address(AP)" in the "M1 Control RS-232 ASCII String Protocol". It is on page 16 of rev. 1.81, pub. date Aug 8, 2011.

Trying to attempt same -- were you ever able to get this working?

Recently I noticed that I was no longer getting notification from NextAlarm when my Internet was down. During the coarse of debugging, I noticed whenever I had the ABN connected, T1 was shorted across R1, T & R. If I disconnect the ABN, nothing is shorted out. No phones are connected, so...

I had a similar problem (exact same error message on my keypad when I tried to see thermostat temp) with an HAI RC 80. I went ahead and followed directions by writing a rule which set a set-point (figuring that while I was in elkrp, I might as well write the rules). Just for giggles, I...