Recent content by tyler electric

1 day programmable insteon venstar thermostat with insteon adapter. Worked fine when I took it down a few weeks ago. The upper hinge on the door is cracked a bit from falling off my desk this afternoon but it does not really hurt it. Have the booklet that came with it. $50 plus shipping. email...

sold

FYI, this really should not be much extra work for your electrician either and should not result in much additional expense to you.

Mike, Just read through the setup manual and you will have it going in no time. It's actually not that bad at all. Do you have an XEP? i know you have an ISY and integrating it with the M1 gives you a nice setup. My SO was blown away the first evening she came home and opened the front door...

Nevermind....helps if you terminate the signal cables on the ALC hub. The scene switch now controls the off/on functions of the relay just fine.

Hi All, I am setting up a test board to gain knowledge on ALC OnQ products. Does anyone know whether or not an ALC scene switch switch can be used to control an OnQ relay? I would expect so but when I try to set a scene switch to dim a light and turn on a relay the relay does not respond. The...

Chris, lots of xk strings. I hope this helps! Coccontech would not let me upload a ht file extension. Here is the 1st 5 minutes of data up until my motion sensor shut the lights off in the office. 16XK01482132711070100070 16XK3148213271107010006D...

I will get to this tonight and will post results.

Thanks for the info. I will review these links. I do have the center up and running but not the way it should be. I seem to be having the a problemwith the nvidia geforce 6150le card. When I go into the nvidia control panel it only shows a standard tv and does not give me options to use...

I unplugged isy from the lan and rebooted but still not able to connect. I then went into lighting and made sure all the future boxes were checked....some were not, but that still does not allow me to stay connected via the RM software. Thanks for your continued help.

I will give this a try. In the mean time my setup includes: m1 gold hardware version 0.11, Bootware 2.3.2, Firmware 5.1.4 m1xep harware 1.0, bootware 1.1.4, firmware 1.2.12

Thanks for the reply. I'm busy with other projects now but will get back to this one as soon asa time permits.

Chris, I am new to the Elk system so all this items have been purchased within the last 2 months. This is the first time I have tried to use the ElkRM software. It does not look like the xep is rebooting. I bought a serial connection and plugged the xp laptop into the m1's serial port. I was...

Thanks Chris, FYI, I have tried to use the RM software from a new Vista laptop that connects to my linksys wireless router which connects via ethernet cable to the M1XEP and also from a winxp laptop which connects to the router/switch via a patch cable and both computers give me the same...

more info, if I connect and don't do anything.....just stay on the security page the RM will disconnect itself in roughly 45 seconds. When this happens nothing new registers in the monitor. The last lines in the monitor are: 1BSD01001AREA1 009A 16RR33590822611070100065 XMIT: 0Bsd010010065