Recent content by vtek63

I know it says the HAI 8 relay module is to be mounted into the expansion enclosure, but I don't really want to have to buy a separate enclosure just for the relay. Does anyone know if there is a way to mount the relay in the standard enclosure? Thanks!

Thanks for all the responses!! Since i'm putting in all new stuff, I will go with GenII to ensure everything work okay in the future. The Web Mountain GenII switches are only a little more expensive than the SA's from what I've seen so its not bad. Is there a way to tell what generation my...

Looks like digitalAVnew.com is where Web Mountain links to to buy their products. Just want to make sure if anyone has purchased from digitalAVnew.com before. Their GenII switch prices seem pretty good. The HAI UPB PIM that I currently have from a little while ago is GenI I assume so if I get...

I'm looking to start populating my house with UPB Switches and was just wondering which brands of switches out there are better or preferred over others. Thanks!

Finally had some time to play around with this thing again and i removed R3 and R6 and it worked like a charm! Off was actually off with the LED lights. :P I will have to let it run for a while and test it out more to see if it flickers or not. Thanks!!!

I ended up just trying to use up the extra power by plugging in another load (ie. nightlight) and that soaked up enough so that the LED's didn't glow anymore. Not elegant, but it works... And just my luck, my X10 IR controller is acting up now.... :) Thanks for all the replies!

I have an old lamp module and on that site, there is a part on defeating local control on a lamp module. Is that what I want to try to remove the power bleed? Thanks!

I wan to control some under cabinet LED lights with an X10 module and when I tried the X10 Lamp module, there was some voltage leak after the "off" command was sent and since LED's don't need much power, they were still partially on. Does anyone know if the X10 Appliance module (AM466 - 3 Prong...

just tried resetting both and still no go... i guess i'll just have to try another switch to see...

anything else i can try before i bite the bullet and possbily buy another switch to try? thanks!

i tried it on the same circuit as the switch and same thing still... its not finding the module. the PIM is gen1 and i'm fairly certain the switch is gen1 as well. am i supposed to see any signal strength in upstart with just the PIM? or is that only after i add a module? i hope the switch...

It comes up when I click on Details after it fails to find module in setup. I am running UPStart 5.0 Build 2. When the switch isn't in setup mode, it does the exact same thing. Looking at the details also looks the same. I don't have a phase coupler and have a whole house surge protector in...

So I finally got the serial connector for the PIM and hooked it up and tried to use UPStart. It found my PIM and when I tried to use it to find my HAI non-dimming switch, it still can't find it. And yes, I did put the switch into setup mode. These are the details from UPStart when trying to...

It was the serial connector that was different. There was a stick on it with the model number and it was different than the one I ordered for the PIM to PC connection. Hopefully, i'll get the right one this time :)

I did have the PIM plugged in next to a UPS on the same outlet. I'll wait til i get the replacement serial connector and try it out. Thanks!!