Hi Pete, and thanks again. I have a few specific questions before starting with the switch replacements:
So long as I configure the new devices in Upstart exactly like the old ones, is there anything I need to do in PCA after the Upstart process?
Also, assume I'll need a PIM connected to...
Pete, thanks very much for your reply. Sorry for not responding sooner, but apparently new members are the lowest form of life - appears to be a restriction on how often I can post. I did quite a bit more reading, and I think I understand your reply. I'm guessing that the original...
First post here, so bear with me. I have an OmniPro II installed about 2006, firmware 2.11. Typical alarm, temp, lights, audio setup. There are about 75 UPB switches and lamp modules installed, and I've managed to learn the basics of programming buttons, scenes, event-based rules, etc. using PC...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.