Recent content by wbonnell

Thanks Brian that worked perfectly!!! I really appreciate the help!! Bill

I tried installing Elk RMS on a new vista 64bit machine and I installed net 2.0 64bit version but Elk RMS will not run. I am getting some type of net 2.0 error. Thanks Bill

For some reason when I use toggle it only toggles one time then stops - does not toggle multiple times??? I am new to this ISY-99 control, is there any way to make a program to flash the light in ISY and have the elk tell the ISY to run the flash program??? Not sure if this is possible - just...

I went in the rules and cant figure out how to speak "silence"???????

I tried this but used "toggle" instead of on and off. It only switched the light once. How do I put delays in between each toggle???

What I want to do is flash a light on and off a few times in our family room when my driveway sensor goes off. Sometimes the TV's volume is too loud and I cant hear the ELK speaker announcing the driveway alarm. Any help would be greatly appreciated. I am new to the lighting portion of this Home...

How do I incorporate a rule to flash a light on/off when something occurs?? I am using an elk m1g connected to an ISY-99i Thanks Bill

I just set up a ISY-99i with a PLM to control some Insteon lighting. I have linked some of the switches and have them working thru the ISY software. On the configuration screen there are some fields for ELK info. IP address, port number and security code. What is the security code? Also what...

I had set my voice announcements to silence after 11:00pm on non-alarm alerts. I have a driveway sensor set on one of my zones set as 16=non-alarm. I have it announce when it detects vehicles in the drive. I am wondedring if I can still deactivate voices after 11:00pm but keep announcing the...

Do you mean to check the option labeled option 1 or option 2 in the wireless setup or do you mean the "type" in the configuration under that zone??

I am trying to write a rule to close the garage door and then keep trying to close the door up to 3 times if something causes the door to not close properly. Output 19 is wired to the contacts on the opener and output 100 is just a virtual output for using as a timer. Does this look like it will...

So in my above example I would need 4 switches??? Is this correct? Thanks Bill

I have several lights that I would like to control with a Switchlinc 2476d. These lights have multple switches that control them from various locations ie. garage lights can be turned on from laundry room, from the garage in 2 spots or from the basement stairwell. Do I need to put a Switchlinc...

Doesnt the Elk actually put the time in the body of the email??

How do you set the time zone in the Elk - in the sunrise - sunset it is set correctly.