This is strange. This week my VRC0P+3 quit unlocking my doors! Upon troubleshooting by spying on the RS232 port, I see that the VRC0P has stopped decoding all secure messages and it has stopped sending any secure commands to secure z-wave devices!?!
Has this happened to any one else? I'm guessing the clock inside quit working so it is unable to decrypt and encrypt z-wave packets. All non-secure messages are displayed, including a short message upon local manipulation (just not the decrypted message that says how the door was manipulated).
The locks and VRC0P have worked flawlessly for almost two years
EDIT: EXAMPLES
Locally unlocking a door from the inside using the deadbolt lever:
<N053:152,064
Using software to lock a door (door lock does not actuate):
>N53SS98,1,255
<E000
<N053:152,128,210,103,225,009,182,233,204,072
<E000
<X000
As you can see, the lower case decrypted packets that you normally see as feedback are missing?!? Also, the lock does not actuate either (it is a kwikset motorized deadbolt).
Has this happened to any one else? I'm guessing the clock inside quit working so it is unable to decrypt and encrypt z-wave packets. All non-secure messages are displayed, including a short message upon local manipulation (just not the decrypted message that says how the door was manipulated).
The locks and VRC0P have worked flawlessly for almost two years
EDIT: EXAMPLES
Locally unlocking a door from the inside using the deadbolt lever:
<N053:152,064
Using software to lock a door (door lock does not actuate):
>N53SS98,1,255
<E000
<N053:152,128,210,103,225,009,182,233,204,072
<E000
<X000
As you can see, the lower case decrypted packets that you normally see as feedback are missing?!? Also, the lock does not actuate either (it is a kwikset motorized deadbolt).