ElkRP2 Transmitter naming

I have recently upgraded to the ELKRP2 and I am trying to add a new wireless transmitter. I cannot figure out how to set the name of the zone. I only get options for the setup of the zone when I select it. I don't see anywhere I can change or add a name.

I am currently using versions:

Main Program Version 2.0.12
M1G Control Version 5.0.12.0
M1 Control Version 5.0.12.0
EZ8 Control Version 5.0.12.0
ElkComm Version 2, 0, 2, 2
ConvertDB Version 1.4.8.0
ElkSafe Version 1.1.8.0
ErrorDlg Version 1.2.8.0

Anyone had this issue?

You may need to post a screenshot of what you see - because when I open RP2, I can click on any wireless zone, and the top field is "Name". Then to the right are the selections for what you want the system to speak for the zone. It's pretty plain and obvious.

Ok, I feel stupid. While making some screenshots I realized that I was trying to edit the name from the "Wireless Setup" selection which will not allow for you to edit the name. I can, however, edit the name from the "Zones" selection. Thank you for making me go through the process of trying to prove myself wrong