Recent content by buddog

  1. B

    Omnitouch 5.7e beeps

    Interesting. I have no programs except a button for my sprinklers. I do have pc access dealer, and it shows my consoles; two key pads and two 5.7e’s, but not my two 5.7e specifically. I does have a tab for Omnitouch 7 which I do not have. I will look at the security system motion detector...
  2. B

    Omnitouch 5.7e beeps

    Does anyone know if and how the sounder in my 5.7e can be turned off? It beeps when one of my motion detectors sense movement with security turned off. I turned the volume down as low as possible but still get a subdued beep. Wife not liking the beeps! B
  3. B

    Omnipro 2 battery relay and Omni stat issue

    Battery has 12.4 volts without ac input. Its just not transferring to pick up the load. On review of sage advice garnered on this site (Pete), I have disconnected battery for a week and replaced battery as well. Seems as though output 8 issue may be related re board fail? Does anyone have...
  4. B

    Omnipro 2 battery relay and Omni stat issue

    Battery backup will not pick up when ac supply is pulled. Does anyone know where the transfer relay is on the board? I saw a tech post somewhere referring to a k3 relay, but my board only has k1 and k2. Fused dc negative has throughput. Also, my omnistats quit communicating. Have no voltage on...
  5. B

    Omnitouch 5.7 to 5.7e

    I have 5.7 touch screens, and one went white out. I have a 5.7e and 90a00-1 to replace it, but can not find instructions on wiring pinout. The 5.7 used 4 wires on the rj485. Can anyone help? Thanks, B
  6. B

    Omnitouch 5.7 Audio List

    I have an Omnipro ii with video hub and two 5.7 touch screens, and Russound CAV6.6. ( I also have controls for sprinkler zones that list properly in the touch screen menus). The audio zone and source lists do not show on the 5.7's. The zones show in PC access (dealer) and on the uno keypads. Any...
  7. B

    Hai Pc acess master code

    In PC access, under setup > codes> I have the following on my screen: # code name description voices code authority areas when on when off dcm on dcm off <- top description line 01 code 1 1111 "MASTER" "123456" "12:AM...
  8. B

    Thermostat Cross Reference

    I am looking for an HAI RC-100 Or OnQ equal Thermostat to replace one with blank screen. Does anyone know if these can be repaired? Send back to HAI? Thanks!
  9. B

    Hai Thermostat

    I am looking for an HAI RC-100 Thermostat to replace one with blank screen. Can these be repaired? Thanks!
  10. B

    HAI RC-100

    Looking for RC-80 and RC-100 thermostat(s) to replace a 100 with a blank screen and add zones to my system
See more
Back
Top