Recent content by CJD

    Thanks again.  Is there a preferred way to reset the board to default? (not somehting I've done before). thanks!

it is at zero (0), though i also tried different values there as well.  thanks for continued feedback.

Yes thanks .  I confirmed port settings in Windows Device Manager to ensure COM# and port settings.  Indeed when I inadvertent set to wrong com port I get a different error message.    I also tried a different serial cable (short serial cable omni-notifier board came with) to confirm it is not a...

Thanks for verifying I am using correct serial cable for PC to OPII (36A05-1) .   And yes I have tried setting all 5 ports (1-5) to Omnilink and wrote to controller before i tried to connect.  I have set both PC and board at 9600 baud,  though also tried other settings down to 1200 baud with no...

I also can not connect to HAI OPII serial.  I have always connected through network so normally not a problem but I now have a need to connect serially.  I did all the usual; Code 1 in PC Access = Master Code in controller,  set port on controller to Omnilink, , tried to power down board, etc.  ...

Thank you ano. I was planning to continue to use the Quickbridge because I already have it installed and it works well, and I didn't want to redo programming for associated hardwired zones. Based on your feedback sounds like 42A00 is the way to go to expand my wireless. Any thoughts on GE...

I have have a wireless application where I need to install several wireless plungers as far as 300' from panel. I have an HAI OPII and some existing wireless zones using an 8 zone hardwired CADXX8016 Quickbridge. I also have a repeater for the Quickbridge. The repeater works absolutely...