Recent content by cmruggiero

Another newbie question.   I have Hifi 2 setup and working stand alone, however, it's not appearing on the Omnitouch's.   I have it connected with the serial cable that came with the unit which I plugged into 1 of the serial ports on the OmniPro II.   In PC Access, I can use 'discover' on the...

Been fooling with it and think I have it narrowed down.    I completely backed out of the install and deleted the O7 from the system, then added it back in - everything worked.    When I go to update the O7 with v1.8 it starts to download in PCA, then the download dies.   At that time, the O7...

I tried that and no luck.   The screen flashes white, then goes blank again - never seems to boot up.    Once it's plugged in again, the green light stays on but the screen itself is black and not responding.

I moved from one house to another and re-established my system in the new house.   Everything was working fine but after an overnight, my Omnitouch 7 went dead and haven't been able to get it working.    The green light still is on, but the touchscreen itself remains off and can't seem to get it...

I now have my security system online and working - effort is to now integrate surveillance.     I have OmniPro II, OmniTouch 7's and Cat 5 & 6 running to all the camera locations.   I also have the HAI Camera Server (although I'm not sure I need this anymore).   What is a good solution for...

As soon as I wrote and posted it, I realized what I did wrong.   Thanks for everyone's help!

The switch lights are green.   I have the router going thru the switch and that works.   The setup is Modem to Switch; then Switch to Router.    If I plug the OP2 into the switch it doesn't work.  If I plug it into the router it does.   Problem is that I need the router in another location so...

Made significant progress and have OP2 now connecting both on the LAN and WAN.   One last issue.   I have a Linksys SE1500 5-port Fast Ethernet Switch.   When I plug the OmniTouch or even the OP2 into/thru this switch it no longer allows me to connect.    The OP2 and OmniTouch's only will...

I was able to directly connect to the OP2 from my PC.    Does that mean that my board is ok and it's a router setting?     I still can't connect via my home internet, nor is the IP address of OP2 appearing on the network.   I have a few OmniTouch 7's that won't work unless I can get the OP2 on...

I recently moved and took my OP2 with me.   New house has new modem (Arris TM822A) and router (Linksys WRT1900ac).       I can't connect to OP2 via PC Access, nor can I ping the IP.   I've read through all the posts related to this issue but can't seem to find the correction.   On the board...