Recent content by dragonsoul84

I did try to re flash the 1.3.8 fw and it did not help. I went ahead and did the 2.0.2 few update and it appears to be working again. I even set up a few emails using an SMTP server that previously gave some trouble and the emails work great as well.

OK, I think I will go ahead and install the new 2.x firmware and if I'm lucky, my problem will be solved. Interestingly, I found the XEP diagnostic utility when going to the support site to get the new firmware. When I ran the utility it informs me that my "M1XEP's MAC address is invalid. Please...

Does it operate and perform pretty much the same minus the java interface? I've never needed the java interface and pretty much only use it for connecting with MyKeypad, and programming. Emails haven't really worked right even when using non SSL email providers. Some of the things I read almost...

The inability to roll back to 1.x and the cautionary note that if everything doesn't go right, you have an expensive paperweight are the reasons I haven't attempted to upgrade it yet. The only advantage to me would be the higher compatibility with SSL email services, but I'd rather deal with...

I wanted to do this, but looking at the manual I was only finding information on shorting J2 jumper to switch between DHCP and default IP, not defaulting entire module. How do you go about defaulting it to blank slate?

I am trying to update some settings in my XEP module (remove Dynamic DNS info, update time server info, and update DNS server). I can connect on the local LAN using ELK RP2 2.0.20. The software tells me there is a conflict with the XEP setup and do I want to receive, or send. If I choose...

I have an ELM M1G with M1KP keypad. The problem I am having is that whenever my alarm is tripped (eg. open window, siren sounding, etc.), the keypad only display "Burglar Alarm." If I press up or down arrows it just displays currently faulted zones or no faults if that may be the case. I have...