Recent content by e2djonline

I am getting the same results as Jlipsit. This is disappointing. How do I downgrade?

Sonos Connect.

The OP2 supports up to 8 wireless transmitters. The HAI/GE receiver is used only if you are using GE wireless sensors. This will not give you any more hardwired zones. If you need more hardwired zones you will have to go with an expansion enclosure or expansion board. If you are wanting to use...

I have tested HAI switches both the 35A00-1 and 35A00-1CFL. I am using 2 Sylvania LED par 30s. From my tests the non CFL dimmer (35A00-1) works better. The 35A00-1CFL was terrible. The flicker was unacceptable. I ended up putting a Lutron RA2 system in instead. The RRD-6NA is great for dimming...

1) Click the settings icon, then hold the settings icon, click save and exit and the OmniTouch 7 will pull the new config file.  2) No real guide on the programing. You cannot configure much from the OmniTouch 7 itself.  3) In PC Access 3 under help then contents, it contains the manual for the...

If you do not want security go with the Lumina Pro. The Omni and Lumina are identical except the Omni has the security enabled.    I have not had much experience with ELK so i'm not sure what it includes. With the Lumina Pro can easily do everything you need to accomplish.    As for pricing not...

I would do that but the mac mini is hosted in a data center on the other side of the country. Do you know any way to block network access to Haiku until I reset the settings?

It is strange. I am using smtp.gmail.com. I installed HaikuHelper on another mac and it is not having any issues. When I hold the shift key it shows the scripts have not been run at startup, then HaikuHelper freezes and I cannot close the info windows with the script message. Any other...

I have installed an Omni lle with RA2. You need to take into account how many lights you want to control. Even though the RA2 can support up to 100 addresses for a level 1. It depends on if you get the Omni Pro II which supports 256 lighting addresses or the Omni lle which only supports 64...

That fixes the issue for opening the program, but it freezes every time it tries and to send an email.

    The Hi-Fi2 has 2 line-level outputs zones 1 and 8. I agree with Neurorad about coming out of the Hi-Fi2 via line-level and going into the input on the AVR. Let the AVR do the switching and power the speakers for the 5.1 system. The Hi-Fi2 can power the other zones in the home. 

That worked to stop the garage about a foot up. Is there a way to make it stop less then a foot? So far I have tried to change the flag time to one second which is too short and does not trigger the door to stop and 2 seconds stops it at a foot. Any way to make a half a second?    Thanks

Just tried that. No luck... Any other thoughts?   Thanks

The door opens, I cannot get it to stop though. When I send the on output to the relay from PC Access, it works with ON for 1 Second. Then I send that command again and it stops. It just does not work in programing.    Thanks

HI, I am having trouble trying to make block in PC Access to open the garage door just enough for the cat to get in and out. Here is my current block.   Thanks