Recent content by fcroisetiere

Waited a few days and things are back to normal now...... I'm puzzled

I did reset my PIM to factory reset..... didn't work better

Last week I got a low batterie warning.... didn't know how much time I had to replace it I was in vacation, on my return at 3am everything start buzzing..... Battery condition warning at the panel. I unplugged the panel and the batterie everything when down..... The next day I replace the...

I'm using HAI, still got RSSI 0 after relocation, only 1 of my 3 sensors is having false Alarme...

I switched the dimming function off and the light is not flickering anymore!!! the led is flashing but the light is not turning off!!! more digging!     Francis

I have the exact same situation here, Except that in my garage my HAI switch does not flicker, but the switch is set to non dimming since it is plugged to neon tube, else where they do flicker, I will try to set the dimming function off to see if there is a difference. My SAI switch are not...

I'm still getting a lot of RSSI=0 and false alarme, I will try to relocate my receiver tomorrow and see if it does help, since the receiver is a treated as a console, may I connect the receiver to a console instead of the panel? that should give me a chance to mount it hire without making hole...

How and where is RSSI logged?   Sorry for asking with the search I landed on page 3 without seeing all the other pages... i'am now loging me RSSI thank you.    

I just finish the wiring to get that project kicked out.... I will report shortly.

This is right jlehnert! it is use by the phone to let you now what zone or interface you are controlling. whumphrey you can press # on your phone to access the Omni and listen to some message, but then the Omni mostly use the zone or unit number to refer to devices. But if you script a call...

I do have an HAI wireless receiver and 4 transmitter, I installed everything last year on that I have 2 IR sensor, one is working proprely, the other one goes by itself about every hours or so, I even place it in my drawer and still it was login as trigger, then I have 2x 46A00-1 that rely...

They are rated at 1500w, I look thru the forum and read a lot about the RC, I will go that route, it is just so much better. I will stick with the Aube Technologies relay since they are a local company and they are not using mechanical Relais but triac instead. I think I will replace my Nest for...

Cheked out the RC1000, look like this will be better than my remote sensor.... I think I will go with 4 of them.... I thought that the RC was only for HVAC and not electric baseboard!

That is the thing, I'm trying to skip the thermostat and use only temperature sensor, is it better if I use a thermostat? There is an Aube Relais with 24v?

I'm in the process of finishing my basement and I need to control 4 baseboard with my HAI. Here's my plan: -Install an HAI 31A00-7 in each room where I have a base board. -Read the temperature from the 31A00-7 with automated bloc to drive the output of the Omni That drive a Aube Technologies...