Recent content by johnlaroux

Thank you  vc1234   I guess silicon labs pc controller software is not backwards compatible.  I can still use my vrcop for changing configuration parameters in my zwave devices.  Now I can stop being insane.  I hear the definition of insane is trying the same thing over and over  expecting a...

    I was talking about the button on the bottom right in this pic.  Named configuration parameters, but thanks for your reply.   [sharedmedia=gallery:images:1163]

Hi vc1234   After reading your entries I bought the ACC-UZB3-U-STA UZB stick  to see if i could replace the controlthink stick im using now.   Only problem I ran into was i'm not able to get the configuration parameter list from any of my devices.  It says retrieving the list was unsuccessfully...

maybe better luck here.       http://cocoontech.com/forums/forum/69-cai-webcontrol/

Don't forget you have to set the clock in the lock also if you want the schedules to work properly.

  Here is what that lock will report.  Look on page 8.   http://s7d5.scene7.com/is/content/BDHHI/ApplicationNote-UsingASCII-Z-Wave-Locks

I just take the value in Param 5 and multipy by 256, then take that sum and add Param 6 to it.  

  Well sorry for the trouble but I figured it out.     In the network setup page, the Primary and Secondary  DNS Server  addresses were set at  0.0.0.0   instead of   8.8.8.8   Email is now working fine.     Thanks  John

    Yes on receiver's email address.  Yes I saved configuration for each change I make.   I have the latest firmware.  Spam can't be disabled but Cox does mark as spam and sends to inbox.   I did send you a message with a url to my board so you could connect to it and make any changes you want...

    So  now I have smtp host as  smtp.cox.net   port 25  username and password blank    From address, my email address.  I click the test button on EM1 and it says its sent but  no emails are received.  

Well I looked at my  thunderbird settings for email and its    smtp.cox.net     with port 587   authentication method says encrypted password.  So maybe its the encrypted password thats not allowing email to work with the webcontrol board??

Yes I meant 587.

I'm having problems getting email to work.  I have Cox email .  Does anyone out there have Cox email and have it working.   I tried using port 25 and 567 and am using smtp.west.cox.net   but it won't work.

  Yes this works great. Now I can practice the plc programming when Im away from home.