Recent content by watchdogfl

Also of note, the exterior temperature sensor is also not reporting temperature data.  It is attached to Zone 1 on an expansion board.  I may be grasping at straws here, but it just seems curious to me that all the other functions on the board are working perfectly except for the thermostats and...

Well, after some time, I've finally had time to do some additional debugging.  Still no solution.  Here is some new information:   If I disconnect all the wiring to the outputs: I get output fault, pressing output reset button does not remove the output fault. If I connect the thermostat again...

I have an OmniPro II in my new home with the X10 controller.  Only a couple of light switches (exterior lights) are currently controlled.  I want to expand to more exterior and interior lighting as well as locks.  I've been reading up on the various technologies and found this device that...

I just recently upgraded my HMS1100 to an OmniPro ii via the firmware chip replacement for my new home.  I also purchased PCA (dealer) and have been able to configure the connection, pull and push settings, etc.  Everything seems to be working just as before the chip upgrade except for the RC80...