Greetings, I have had an Elk M1 system up and running now for about 2 years in a new house build with smoke detectors and wireless window sensors. There is no expertise available where we live so I am it for the support team and have done all configuration work thus far. The house was hardwired for door sensors and motion detectors and the wiring to the Elk panel for those devices was just completed yesterday. I am trying to figure out the correct configuration within the Elk for the door sensors which are Honeywell 944T contacts.
I've configured them within the Elk as Definition 03 = Burglar Perimeter Instant and Type 0 = EOL Hardwire / Wireless
Every door (Doc attached) shows a status of VIOLATED, with state of OPEN.
I'm trying to figure out if I have a configuration issue or a wiring issue. Any help most welcome, thank you.
I've configured them within the Elk as Definition 03 = Burglar Perimeter Instant and Type 0 = EOL Hardwire / Wireless
Every door (Doc attached) shows a status of VIOLATED, with state of OPEN.
I'm trying to figure out if I have a configuration issue or a wiring issue. Any help most welcome, thank you.