After a lightning storm, all 3 of our 38A06-2 6-button keypads no longer run the programs on our OMNI IIe, and the keypad LEDs no longer respond to instructions from the OMNIIe. The keypads still have LED lights and still buzz when I press a button, but they don't do anything.
So I wanted to go through the keypad setup again but I can't remember how the OMNIIe knows one keypad from the other. The 38A06-2 instructions are no help with this.
I never used UpStart with any of the Omni programming.
Each Keypad is listed as a UPB "UNIT" in HAI Dealer Access and each of the 18 buttons and LEDs are all programmed in the OMNIIIe.
So how do I configure the keypads to talk to the OMNI IIe as they did before. Keypads had no direct communication with switches or dimmers . . all scenes were driven by programs on OMNI.
(This whole system was messed up after this storm. I had to upload the programs to the OMNIIe from the .pca file to get things working again. All the HAI switches work now, but the keypads don't)
.
So I wanted to go through the keypad setup again but I can't remember how the OMNIIe knows one keypad from the other. The 38A06-2 instructions are no help with this.
I never used UpStart with any of the Omni programming.
Each Keypad is listed as a UPB "UNIT" in HAI Dealer Access and each of the 18 buttons and LEDs are all programmed in the OMNIIIe.
So how do I configure the keypads to talk to the OMNI IIe as they did before. Keypads had no direct communication with switches or dimmers . . all scenes were driven by programs on OMNI.
(This whole system was messed up after this storm. I had to upload the programs to the OMNIIe from the .pca file to get things working again. All the HAI switches work now, but the keypads don't)
.