My problems started when I installed a new expansion enclosure - before then I had a rock-solid stable system with wireless and a single hardwire expander.
I started getting intermittent 'no controller data' messages on one or the other of the consoles.
The problem now is that even when I disconnect all expansions from the main board, I still get the same issue with the consoles. I have tried wiring them directly onto the board to rule out any wiring issues (makes no difference) and I have triple-checked that there is nothing silly like wiring an A data connection to a B. I have also tried disconnecting the network as I read something about the lan port possibly being flooded.
At one point, no console was being recognised at all. I performed a full reset of the board (10 minutes with power off and no battery) after which I got back to the intermittent 'no controller data' error message, which is followed by a disarm prompt (the system is not armed) and beeping. Then, after about 10 seconds it goes back to normal for another minute or so.
Any ideas?
I started getting intermittent 'no controller data' messages on one or the other of the consoles.
The problem now is that even when I disconnect all expansions from the main board, I still get the same issue with the consoles. I have tried wiring them directly onto the board to rule out any wiring issues (makes no difference) and I have triple-checked that there is nothing silly like wiring an A data connection to a B. I have also tried disconnecting the network as I read something about the lan port possibly being flooded.
At one point, no console was being recognised at all. I performed a full reset of the board (10 minutes with power off and no battery) after which I got back to the intermittent 'no controller data' error message, which is followed by a disarm prompt (the system is not armed) and beeping. Then, after about 10 seconds it goes back to normal for another minute or so.
Any ideas?