Over the years I have gotten my OP II programs into a circle jerk where the trigger would be reactivated by the action over and over and ultimately the OP II would go off line and freeze up to various degrees.
I would then blame the problem on other things like the network, & other devices etc. and finally conclude it was my program by reverting back to an older program and then paying close attention to changes I had recently made.
I am also thinking that my system could be slowed down especially on motion sensor/ UPB lighting commands by a more minor circle jerk program fault which doesn't freeze up the OP II but loads it down unnecessarily.
These cyclic programs are very difficult to find.
Is there a Task Manager for the OP II which will show activity like it does for the CPU in windows??
I would then blame the problem on other things like the network, & other devices etc. and finally conclude it was my program by reverting back to an older program and then paying close attention to changes I had recently made.
I am also thinking that my system could be slowed down especially on motion sensor/ UPB lighting commands by a more minor circle jerk program fault which doesn't freeze up the OP II but loads it down unnecessarily.
These cyclic programs are very difficult to find.
Is there a Task Manager for the OP II which will show activity like it does for the CPU in windows??